What can be done well in injection molding to prevent the trouble

  Injection mold is a craft, it is divided into thermosetting and thermoplastic two kinds, according to the molding process can be divided into six kinds. Injection molding main
Is the production and processing of some of the more complex shape of the material, mainly will melt the plastic injection molding machine into the material, the final cooling molding.
But in this process, there may be some accidents, in order to avoid accidents, we should do the following work.
1: During the working hours of plastic mold, employees can't wear slippers. If there is a number in the workshop, iron objects will crush the feet to prevent floor damage
Slips and falls. Up and down the mold, technicians and foremen must wear protective shoes to go to work to prevent bruises.
2: When using the blade, the plastic mold manufacturing staff must face the blade outwards, not to themselves, in order to prevent negligence.
3: All employees should not wear long hair when they go to work. Women with long hair should tie their hair together. Don't wear a long pendant on your chest to avoid other injuries
an accident.
4: In case of any machine abnormality, the employee shall find a technician to deal with it in time. Do not disturb the machine, such as cutting off water, sticking mold, no product, etc
The hand and head extend into the mold to prevent the machine from failure and pressing on the hand.
5: Always check the two-way switch when the employee is in the vertical machine. Only one switch is not clamped properly. Press a switch to close the mold
It's not normal. When the horizontal machine is opened, the front door will be closed and the mold will be abnormal.
6: When employees are on the machine, release agent must be placed on the table to prevent high temperature. Do not put it on the machine. When spraying, it is forbidden to use ignition
Machine. White oil and alcohol are strictly prohibited in injection molding department. Some products need white oil and alcohol. Special areas (with special fire extinguishers) must be designated. The
The area shall be separated from the aircraft base and inflammable and explosive articles, and the use of white oil and alcohol (placed on fixed shelves that are not easy to ignite) shall be restricted, and the area and
The limit shall be determined by the supervisor and reported to the manager for approval and supervision by the general assistant.